What Causes Welding Spatter

17 reasons why you are getting spatter in your welding operations

Spatter is present in welding.  It’s all over welding.  But it doesn’t have to be.  Spatter costs fabricators millions of dollars every year.  Its removal constitutes rework that significantly and negatively impacts productivity.  Many fabricators work under the assumption that spatter is a necessary evil, a part of welding.  However, this couldn’t be further from […]

Short-arc vs Globular Transfer in GMAW

What is the difference between globular and short-circuit transfer? Short-circuit is a mode of metal transfer in GMAW in which metal is transferred from the electrode to the weld pool via a series of electrical shorts. When the electrode (wire) touches the base material a short occurs and the arc goes out.  At this point […]

Modes of Metal Transfer: Spray

Spray is a mode of metal transfer in which a fine spray of metal droplets are projected axially from the tip of the electrode to the work.  These droplets are smaller in diameter than the electrode.  This mode of transfer is characterized by high wire feed speeds (high amperage), high voltage and consequently high heat […]

Modes of Metal Transfer: Globular

In our last post we explained short circuit transfer; if you missed it you can go back and read Modes of Metal Transfer: Short Circuit.  In this post we’ll spend some time going over globular transfer by covering its basics as well as its advantages and limitations. Globular transfer occurs in GMAW and MCAW processes […]

Modes of Metal Transfer: Short Circuit

The modes of metal transfer refer to the different ways in which the filler metal (electrode) is transferred through the welding arc and into the weld puddle.  We can write a book on this topic but we’ll keep it simple to provide an understanding of the different modes of transfer, what they require and what […]